Underbody seal Special
Underbody seal special
UBS-SPECIAL-BLACK-500ML
Register now and access more than 15,000 products
- Excellent adhesion to wood
- Tested compatibility with commercially available
- wood impregnation compounds
- Excellent anti-humming effect
- No run-off on vertical surfaces
- Highly resistant to ageing
Store the product in a cool, dry place. Recommended storage temperature +10°C to +30°C. Protect from direct sunlight. Product can be removed again after application with thinner. Once dried, the product can be removed again only by mechanical means. Turn the can upside down and spray until the valve is empty after use.
The usage instructions are recommendations based on the tests we have conducted and our experience; carry out your own tests before each application. Due to the large number of applications and storage and processing conditions, we do not assume any liability for a specific application result. Insofar as our free customer service provides technical information or acts as an advisory service, no responsibility is assumed by this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting deliberately. We guarantee consistent quality of our products. We reserve the right to make technical changes and further develop products.
Datasheets(X)
Special underbody seal for use on wooden underbodies of caravans, motor homes, trailers etc. Thanks to the active-breathing properties of the underbody protection, moisture exchange of the wood is ensured. The penetration of moisture and other environmental influences is prevented.
Shake can well before use. The surface must be dry, clean and free from rust and grease. Optimum spraying distance: 30 cm. With thicker coats, allow intermediate coats to flash off.
Chemical basis | Mix naphtha, solvent, propellant |
Surface pre-treatment required | Surface must be clean, dry and free from rust and grease. |
Contents | 500 ml |
Weight of content | 406 g |
Colour | Black |
Min. proportion of solids | 33 % |
Min./max. temperature resistance | -25 to 80 °C |
Conditions for through drying | at 20°C, 65% relative humidity |
Min. spraying distance | 30 cm |
Conditions for skin-formation time | 20°C, Ri 0 at 65% relative humidity, 100 µ wet layer thickness |
Min. skin-formation time | 75 min |
Drying time | 135 min |
Conditions for drying time | at 20°C and 65% relative humidity |
Density | 0.79 kg/l |
Density conditions | at 20°C |
Shelf life from production | 24 Month |
Max. temperature resistance | 80 °C |
Min. temperature conditions | -25 °C |
Min. temperature resistance | -25 °C |
Recoatable/Can be painted over | No |
Select RAL-colour code
!! NOTE: On-screen visualisation of the colour differs from real colour shade!!